Hypertherm THC Plasma Interfacer Upgrade Bedienungsanleitung

© Copyright 2000 Hypertherm, Inc.All Rights ReservedHypertherm and Command THC are trademarks of Hypertherm, Inc. and may beregistered in the United S

Page 1128503 Kit Instructionscommand THC Plasma Interface UpgradeTo replace the plasma interface assembly or the interface PCB, the command THC must b

Page 2128503 Kit Instructionscommand THC Plasma Interface UpgradeTools NeededINSTRUCTIONSWARNINGELECTRIC SHOCK CAN KILL• Turn off the power and remove

Page 3128503 Kit Instructionscommand THC Plasma Interface UpgradeProcedure1. Turn off the power to the power supply.2 Turn off the power to the THC sy

Page 4128503 Kit Instructionscommand THC Plasma Interface Upgrade4 Remove and discard the 2 microprocessors from the control PCB.GG27 28 29 3010 11 12

Page 5128503 Kit Instructionscommand THC Plasma Interface Upgrade5 Install the new microprocessors into the control PCB.GG27 28 29 3010 11 12 13 1426D

Page 6128503 Kit Instructionscommand THC Plasma Interface Upgrade8 Remove the old interface assembly.9 Install the new interface assembly per therevis

Page 7128503 Kit Instructionscommand THC Plasma Interface Upgrade10 Attach the volt meter to measure the arc voltage between J5-2 and J5-3 in the plas

Page 8128503 Kit Instructionscommand THC Plasma Interface Upgrade14. Put the Command THC in MANUAL MODE.15. Begin a cutting process and compare the vo